Todos los productos
Producto
Shoe GOO Shoe Repair Adhesive
Shoe GOO Shoe Repair Adhesive es un adhesivo Cemento de contacto. Reconstrucción de suelas desgastadas, pegado de calzado deportivo y protección impermeable contra la abrasión.
Puntos fuertes
Para qué sirve Shoe GOO Shoe Repair Adhesive
Reconstrucción de suelas desgastadas, pegado de calzado deportivo y protección impermeable contra la abrasión.
Límites
Cuándo no usar Shoe GOO Shoe Repair Adhesive
Textura espesa en gel; requiere de 24 a 48 h para un curado completo.
Especificaciones
Especificaciones de Shoe GOO Shoe Repair Adhesive
Cada cifra de abajo se cita de la documentación del fabricante, enlazada al final de la fila.
- Fraguado inicial
- 20 min — Tack time 2–10 min; set time approximately 20 min[1]
- Curado completo
- 24 h — Thin film cures in 24 h; thick applications require 48–72 h[1]
- Resistencia
- 3800 psi — Tensile strength according to ASTM D-412 with 900 % elongation[1]
- Temperatura máx. de servicio
- 150 °F — Intermittent service up to 150 °F (−40 °F to 150 °F)[1]
- Temperatura mín. de aplicación
- 50 °F — Ideal application temperature range 50 °F to 90 °F[1]
- Resistencia al agua
- Completely waterproof and submersible once fully cured; resists continuous wet outdoor exposure and puddles[1]
- Se puede pintar
- Yes — paintable to match surrounding shoe or material once fully cured[1]
- Color curado
- Clear transparent[1]
Cuánto tarda
Tiempo de trabajo, tiempo de apriete y curado completo son cosas distintas: este es el orden en que las vives.
- Fraguado inicial20 min
- Curado completo24 h
Fuentes
De dónde salen las especificaciones de Shoe GOO Shoe Repair Adhesive
- [1]Shoe GOO Technical Data Sheet (TDS) — Eclectic Products · Ficha técnica · Consultado el 2026-08-15
Relacionados
Materiales en los que funciona Shoe GOO Shoe Repair Adhesive
Preguntas
Preguntas frecuentes sobre Shoe GOO Shoe Repair Adhesive
- What is the difference between Shoe GOO and E6000?
- Both adhesives are solvent-based synthetic rubber made by Eclectic Products. Shoe GOO is formulated with slightly higher abrasion resistance and thick build properties specifically tailored for walking wear and tread rebuilding.
- How long after applying Shoe GOO can I wear my shoes?
- Wait at least 24 hours for a light thin-film bond. For deep sole repairs or built-up heel layers, wait 48 to 72 hours for maximum cure before heavy walking.
- Can Shoe GOO be used to coat and rebuild a hole in a sole?
- Yes. Apply a piece of tape inside the shoe over the hole, apply Shoe GOO in thin successive layers from the outside, letting each layer set 3 to 4 hours, then allow a full 48-hour cure.
- How do I clean excess or spilled Shoe GOO?
- Uncured adhesive wipes away with acetone, nail polish remover, or citrus-based solvents. Once fully cured, it must be trimmed away with a razor blade or peeled mechanically.